To change the printing speed, you can consult your printer software manual. 3. Reduce the temperature. Reducing the temperature can help your edges stay flat. When your model is hot, no, Warping D print terms means that the shape and structure of the base of your print is warped and distorted. This is only really an issue in FDM printing rather than resin, but it's possible that this figure could go that high, in mm s, depending on the D printer. 3. Lower print temperature. Printing temperature plays a key role in reducing spinning, as it dictates how, Shrinkage Factors: Shrinkage depends on filament type, printing temperature, cooling rate and ambient temperature. Filaments at high temperatures tend to shrink more than those at low temperatures. Withdrawal rate: The PLA has a withdrawal rate. 2 ABS has a higher shrinkage rate and PETG has a higher shrinkage rate. Take a piece of string and hold both ends. One end represents the filament coming out of the extruder, the other represents the filament already wound on the spool. Now try to tie a knot without ever letting go of either end. It's simply not possible. So on the manufacturer's side, the filament cannot get tangled in the center of a spool, therefore.